Wall Thermostat with LCD display plus actuator kit
Secure

Wall Thermostat with LCD display plus actuator kit

Artikelnummer: SEC_SRT322
Utgått ur sortimentet

The SEC is a system to control warm water heating in general and floor heating installations in particular.

It consists of a battery operated wall thermostat installed in the room to be controlled and a relay switch to operate the water boiler.

The thermostat can be manually operated by the user or remotely operated via Z-Wave to set the desired temperature level.

Transmitter
The SEC_SRT321 is a battery operated wall thermostat.
Using a big wheel on the device the user can preset the desired target temperature in the room.
By verifying the target temperature with the measured real temperature closed to the device the unit decides how to operate a wirelessly attached power switch that is attached to the heater.

In parallel a central gateway of Z-Wave control software can set the target temperature using Z-Wave. This enables to realize a time scheduled zone heating. The thermostat itself does not have any internal timers but executes the wireless settings (COMMAND CLASS THERMOSTAT_SETPOINT) and the local setup.

Receiver

  • The SEC_SSR303 is a wirelessly controlled Relay switch to operate loads up to 3 A / 230 V.
  • It is used to control warm water boilers or magnet valves.
  • The device can be operated locally using two buttons.
  • A LED indicated the current switching status.
  • The fashionable design of the device allows mounting it on visible positions in the home.

Skriv en recension

Kompatibilitetslistan uppdateras ganska ofta men fel kan förekomma. Hittar du något som är felaktigt så meddela oss gärna så att vi kan ändra!

Controller Status Kommentar
ZNet Lite V2 Enheten fungerar inte helt och hållet
Home Center HC3 Enheten fungerar helt och hållet i HC2 och HCL
Zipabox Enheten fungerar helt och hållet