Fully connected H-CAN kit-Volvo

Article no.: H-CAN-KIT-VOLVO
Availability: 10st

Speed limit your Volvo in a snap with the fully connected H-CAN kit! Simple as 1,2,3: Connect the gas pedal switch and seal with a wire seal Solder in/power steal CAN bus Attach the box Done! Look up is what your gas pedal connector looks like and choose the ... read more

4 990 kr

Available Options

Certificate * - Write chassis number In the event of an inspection, you need a certificate from us. In order for us to be able to issue this certificate, we must have the registration number of the car.

Cable set for the gas pedal Volvo *

Message

button_wishlist

Speed limit your Volvo in a snap with the fully connected H-CAN kit!
Simple as 1,2,3:

Connect the gas pedal switch and seal with a wire seal
Solder in/power steal CAN bus
Attach the box

Done!

Look up is what your gas pedal connector looks like and choose the correct cable from the list. We then build your H-CAN kit to order.
Fill in your registration number to receive a certificate for the registration inspection.

This pre-wired H-CAN kit includes:

Pre-configured H-CAN for your Volvo model set to 30km/h (double check against GPS)
Accelerator switch
Cables pulled in hose
Mounting box
3 wire seals, one for the accelerator cable and two for the mounting box.

Note! Do not pull the cable seals through the box. The inspection must normally do this.

Connection CAN-BUS:

Depending on the model year you have on your car, we have different ways to access the CAN bus. Younger Volvos after 2005 have CAN L and H directly on the OBD socket, while older models have CAN L and H behind the radio.

Volvo 05 and later: The OBD socket – Check pins 6 and 14 of the OBD socket.
Checking is done by measuring the voltage (Volt) on each pin with the second ignition mode on. You should have approx. 2.5V on each pin. Pin 6 is CAN High and pin 14 is CAN Low (Important! H-CAN should NOT be grounded in the OBD socket)
Volvo 00-04: Behind the radio – Green and White cable behind the stereo, in the stereo connector.
Here you have two cables that are twisted together, white is CAN High and green is CAN Low.
Volvo S70 and V70L: Under the wiper arms – Green and White cable under the plastic protection of the wiper arms there is a thick cable trunk. Here you will find the green-white twisted CANBUS cable pair. ATTENTION! In the S70 and V70 L, the regulator must have a constant +12 supply, not supply from the pedal. (write in the message field above) if you have a Volvo S70 or V70L, we solve the power supply from H-CAN.

Kopplingsschema

Instructions for the H-CAN Volvo, See here.

Instructions for our ready-made cabling, See here.