SYN 900 MHz +23dBm repeater (10 MHz BW)

Article no.: SYN-E23L-S
Delivery time: Est. delivery 7d

SYN-E23L-S is a band selective (10MHz width) 900MHz repeater specially developed for Swedish requirements and wishes. Maximum 10 MHz bandwidth. Fits Telia's 900 or Tele2/Telenor's 900 only the 2G part (or only the 4G part) Also fits Tre with 5 MHz bandwidth (925-930/880-885) due ... read more

13 549 kr

button_wishlist

SYN-E23L-S is a band selective (10MHz width) 900MHz repeater specially developed for Swedish requirements and wishes.

Maximum 10 MHz bandwidth. Fits Telia's 900 or Tele2/Telenor's 900 only the 2G part (or only the 4G part)

Also fits Tre with 5 MHz bandwidth (925-930/880-885) due to physically locked minimum frequencies 925 /880 MHz.

This model is adapted for surfaces up to 4000m3. It is programmable so that the installer can change the center frequency. In addition, the possibility to configure a number of other parameters via the Touch Screen

SYN-E23L-S has a built-in "Uplink Sleep Mode" or so-called "Silent Mode" that protects the operator's base stations from noise/load when no one behind the repeater is speaking phone. That is, the repeater turns off the signal to the operator's base station when there is no traffic behind the repeater. This happens in milliseconds. This is a function that is usually only found in more powerful and significantly more expensive repeaters.

The repeater normally runs in a fully automatic mode that tests signal strengths and possible signal leakage between internal and external antennas during start-up to set up the repeater and alarm if it detects potential signal leakage that could result in looping.

The repeater also has automatic shutdown in case of excessive signal leakage or looping. Everything to prevent problems for you and the operators.

An LCD display shows signal strength in and out as well as amplification factor both in uplink and downlink as well as center frequencies in Uplink/Downlink.

Normally the repeater is run in auto mode. But if you need to manually set the gain, do it via the touch screen.

Regular antenna connectors (N-type) are screwed into the metal chassis to be able to connect even coarse cables.

Unique features of SYN-E23L-S

A real band selective 900 MHz repeater (ie acceptable by the operators)
LCD Touch Display but setting of gain and Uplink /Downlink frequency
Uplink Sleep Mode - saves resources for the operator
High output power for multiple indoor antennas - +23 dBm
RED CE/3GPP tested and approved.< /li>
Adjustable center frequency (mainly think for Telia)
Automatic adjustment of gain
Built-in protection against round trip/self-oscillation
Automatic test procedure of antenna separation, signal strength and gain during startup

How to find out if you can use a 3G repeater

3G Repeater FAQs and Repeater Permits

Here you can find Tele2's (also Telia 3G) coverage map with transmitter locations (NOTE zoom to the 200 meter level to see the location of the transmitters)

Our Swedish operators' frequency bands

Manual